Offer 377703, a BOBST SP 104-E from 1997

Platform with safety barrier, <>Centerline system for quick job changeover, <>Electronic device for sheet travel control, <>Adjustable centering at the stripping and at the delivery, Air conditioning for the electrical cabinet, <>Gripper bars, <>Bobst Electronic System for management of the machine, <>Main motor with frequency variator, <>F-9 PRE-SETTING TABLE : Adjustable. Allows the preparation of a second job during production, reducing machine makeready time and increasing the time available to run production. <>Requires: a series of supplementary stripping tools, <>Pile-tray with handle allowing manual lateral correction of the pile during production, <>Pile height control at the front edge thanks to a photoelectric cell, <>Pile rear guide (OS and OOS sides), <>Adjustable lateral blowers with Centerline references, <>Suction unit with multiple adjusting, <>Safety system for lowering the pile try, <>C-4 NON-STOP FEEDER MANUAL DEVICE, <>C-8 VERTICAL POSITIONING OF THE SUCTION UNIT. <>Eliminates manual interventions to compensate for the flatness of the pile shape, <>Covered with an anti-static stainless steel plate, <>1 Inlet table feeder, <>4 front lays, adjustable in pairs with front register control, <>1 Pull-lay operator side (OS) adjustable according to Centerline, with sheet control, <>1 Double sheet detector, Support plates at entry of platen station, <>1 Sheet-hold down device (guiding the sheets to front lays), <>1 Upper frame with manual lifting device, <>1 Upper transport equipment for paper, paperboard and corrugated board, <>4 Transport belts. With lateral guidance, C-5 CONTROLLABLE SHEET ARRIVAL FOR PERFECT SYNCHRONIZATION OF SHEET ARRIVAL AND REDUCTION OF MACHINE STOPPAGES, <>Grippers re-opening device, <>Die-cutting device without band of gripper grip, <>Equipment centering and locking, <>Locking of the chase against the upper beam, Measurement of the die-cutting force with strain gauge, <>Resocell: synthetic material supporting plate. <>Thickness 22.5 mm, <>1 Upper chase with quick locking: fixed bottom (E-3) Plate, <>thickness 2 mm and make-ready protection plate of syntetic material, <>1 mm thickness, <>E-5 COMPENSATION PLATE 4 mm thickness. it's useful for thin plate for repetetive work, <>E 55 ADJUSTABLE SUPPORTING PLATE CENTERINGS : micromeric screws allow fine adjustment of counters mounted on the cutting plate with respect to the die (+/- 0,9 mm lengthwise and crosswise., <>3 drawer frame system,<>1 Upper Stripping Frame (F-2), <>1 Upper stripping equipment (F-21) required to create a waste stripping tool, including crossbars, clamps, stripper holders and stripping pins of 3, 5 and 10 mm of diameter, <>1 Fastening equipment for stripping die (F-22), <>1 lower pull-out frame (F-8), <>1 Lower stripping equipment (F-81) Equipment for waste stripping including crossbars, pins and supports, <>F-31 1 UPPER PULL-OUT FRAME QUICK LOCK. It reduces stripping tool assembly times; the quick-closing device allows the tool to be changed in the machine), <>F-72 1 CENTRAL PULL-OUT FRAME QUICK LOCK, <>Pile tray in delivery, Adjustable rear and side joggers with Centerline marks, 1 Braking brush, <>Pneumatically controlled adjustable front joggers, <>G-5 AUTOMATIC NON-STOP ON DELIVERY, <>Operator safety devices, <>Gripper Bar Chain Slip Clutch, <>Gripper bar chain locking device, <>Handling of the diecutting equipment, Emergency Stops